8/8/2023 0 Comments Atlas lathe videos![]() ![]() ![]() I'm currently rebuilding a Rockwell 15" drill press and have discovered soda and Co2 blasting. It's too easy for the guy to blast something that shouldn't be, but if you can control the blasting and mask well, that would be different. For the bed surface I scrubbed it well with Scotchbrite and kero, and ran a large, new, file along all sides to knock down any pips that had been raised from impacts, and that was it.Īs for finishing, first I would prefer not to sand-blast anything. I used Scotchbrite wheels to brighten up misc bare metal but NOT on plated or ground surfaces. I used furniture paint stripper on stubborn stains or grunge, but generally I got by with very little of that. Most of the cleaning work was done in a home-built parts washer using kerosene (parafin) as the solvent and various bristle brushes and scouring pads, Scotchbrite, etc. The bare metal on the restored one, in particular the critical surfaces such as the ways and spindle, were all in very good condition so one of the challenges was to protect these during restoration. The photos are of different machines but the restored one (photo 2) was in about the same condition as in photo 1. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |